Re V1 Dmg Mori

• Mazak

• Forum Actions
• Quick Links

Used vertical and horizontal machine centers CNC: https://www.facebook.com/vmccnc. Contact your DMG Mori representative or call their hotline at 1-800-DMG-MORI (800-364-6674) if you have any questions about support or upgrade on a Mori Seiki CNC machine. Mori Seiki and DMG Mori Product Lines. Over the years a number of Mori Seiki and DMG Mori CNC machines have been made and sold all over the world. DMG MORI AKTIENGESELLSCHAFT is a stock corporation under German law with registered office in Bielefeld and has issued shares with voting rights, which are listed on a regulated market within the meaning of Section )(7 of the German Securities Acquisition and Takeover Act 2. HVExplanatoryReport en v1.indd Created Date.

• Thread Tools

• Display

  • Linear Mode

1. Plastic

   Join Date

   Feb 2011

   Location

   singapore

   Posts

   7

   Post Thanks / Like

   Likes (Given)

   0

   Likes (Received)

   0

   Alarm 32 (IPM detects over current) on MITSUBISHI SPINDLE DRIVE MDS-C1-SPM-260

   Dear Friends,
   We have a Mori Seiki SL 204 CNC Lathe with MAPPS MSG-501 Controller. Spindle and Servo Amplifiers are MDS-C1-SPM & MDS-C1-V2 Series from Mitsubishi.
   Occasionally during CNC operation, Spindle would suddenly stop and rock forward /reverse for few seconds. CNC would then generate Servo Alarm 'PR 003E' & the Mitsubishi Spindle drive 'MDS-C1-SPM-260' show an alarm '3E' on its 7 segment LED display. To overcome this fault, we would do a total machine shut down and restart all over. Machine would again work good, until such time the above happens again.
   From a machineries dealer, we picked up a used, but working Spindle Amplifier module 'MDS-C1-SPM-260' (same as above model) and replaced it on our machine, to solve the above nagging issue.
   But now when we start the Spindle with this 'new drive', CNC would instantly generate a 'Servo Alarm PR 0032' & the 'new' Spindle drive shows an alarm 32 on its LED display. Alarm 32 = The IPM used in the amplifier detected 'High current'.
   We were told, the replacement Spindle Drive is a good, working unit. So now, we suspect the parameters inside the two Spindle Amplifiers are different and therefore parameter(s) setup is needed for the 'new' drive to work good. Can we access to Spindle drive parameters from the MAPPS MSG-501 Controller? Does anyone have a procedure for re-establishing the parameters into the 'new' drive from the original one above? If & when this is done, we'll give it another go to try & see if the replaced Spindle drive works normal on our machine.
   any ideas? thanks again everyone.
   sam

Mazak

• Site Areas
• Forums
• Manufacturing Today
• Specific Machine Forums
• Open Discussion
• Commerce
• Machinery Manual, Brochure and Photo Archives
• Forum features

Posting Permissions

• You may not post new threads
• You may not post replies
• You may not post attachments
• You may not edit your posts

• BB code is On
• Smilies are On
• [IMG] code is On
• [VIDEO] code is On
• HTML code is Off